TEKNOHEAT 500-100 CS

Before cleaning of surface, it is recommended to wash it with water with addition of OLICLEAN 123 and then rinse with fresh water. Remove from the surfaces any contaminants that might be detrimental to surface preparation and application. Steel surface cleaned to the degree of cleanliness at least Sa 2½ according to ISO 8501-1. In case of amendment after assembly or to correct small defects of layer it is allowed to repaint it with TEKNOHEAT 500-100 CS but the surface must be cleaned to PSt3 degree. In that cases, well adhered paint surface should be intact. The surface prepared for repainting must be free from oil, grease, dust, mill scale and pure adhering rust, old paint surface and other contaminants or impurities. Additional instructive information for surface preparation can be found in standards EN ISO 12944-4 and ISO 8501-2.

Stir thoroughly before use. Apply by airless spray, air spray or brush. Suitable airless nozzle size 0.009 - 0.013" Nozzle pressure 10-15 MPa. In case when paint is applied on ethyl zinc silicate coat it is recommended 25% dilution of TEKNOSOLV 1639 and application the first layer in thickness not more than 30µm (wet film).

The surface to be treated must be dry. During the application and drying period the temperature of the ambient air, the surface and the product shall be above +5°C and the relative air humidity below 80%. Additionally, the temperature of the surface to be treated and the product must be at least +3°C above the dew point of the ambient air.

The storage stability is shown on the label. Must be stored tightly closed and kept cool and dry.