HOLZSTAUBBINDEMITTEL 0340-00

Every substrate must be well-cleaned, dry and free from grease and oil. Coating removal: Sand

Stir or shake the product well for several minutes before use, if necessary by machine.

Recommended temperature for surroundings and product: +15°C-25°C. Do not apply below +10°C. Ideal surface and object temperature for application: +18°C-22°C. Avoid application in direct sunlight. Underfloor heating systems must be adjusted well in advance.

For further information on products for treating the surfaces of wooden floors and their use please visit www.parkett-verband.ch.

Storage temperature is +5°C - +30°C. Store in a tightly closed container.

Only use up to a maximum joint width of 2 mm. Put the HOLZSTAUBBINDEMITTEL 0340 in a container, stir in the wood sanding dust with a spatula. Depending on the desired consistency, add wood dust or HOLZSTAUBBINDEMITTEL 0340. Mixing ratio: Mix 15-20 g of wood dust with 100 g of the wood dust binder. Required quantity: 40-50 g of the wood dust mixture is sufficient for an area of approx. 1 m². The required quantity can vary significantly depending on the type and extent of joints and dents. Trowel-fill, sand. Can subsequently be reworked with all parquet floor primers and/or all water-soluble parquet coating systems, oils as well as all solvent-based parquet floor sealing coatings. Does not cause discolouration on the wood.