AQUAFILLER 1151-00
Primer
- Primer
Water-borne primer for wooden laths and doors as well as MDF and fibre board indoors. Before using the product, the manufacturer should be contacted to check the suitability of the product for the object in question.
Wooden laths and doors as well as MDF and fibre board indoors. Before using the product, the manufacturer should be contacted to check the suitability of the product for the object in question.
The paint dries quickly and it is easy to rub down. Gives a surface with good filling properties and which can be topcoated with water-borne paints. Recommended for roller coating and spraying.
Technical data sheet
Safety data sheet
- AQUAFILLER 1151-00_TS 20385 BEIGE_2023-11-17_EU_en
- AQUAFILLER 1151-00_TS 20385 BEIGE_2023-11-17_GB_en
- AQUAFILLER 1151-00_TS 20385 BEIGE_2023-11-17_IE_en
- AQUAFILLER 1151-00_TS 20385 BEIGE_2023-11-17_MT_en
- AQUAFILLER 1151-00_TS 20385 BEIGE_2023-11-17_NI_en
- AQUAFILLER 1151-00_TS 20701 WHITE_2023-11-23_EU_en
- AQUAFILLER 1151-00_TS 20701 WHITE_2023-11-23_GB_en
- AQUAFILLER 1151-00_TS 20701 WHITE_2023-11-23_IE_en
- AQUAFILLER 1151-00_TS 20701 WHITE_2023-11-23_MT_en
- AQUAFILLER 1151-00_TS 20701 WHITE_2023-11-23_NI_en
Surface preparation
The surface to be treated must be dry, clean, and free from dust. The surface should be well smoothed to reduce rising of wood fibres.
Sanding is recommended.
Application conditions
The moisture content of the wood is to be below 20%.
Stir thoroughly before use.
During the application and drying period the temperature of the ambient air, the surface and the product shall be above +15°C and the relative air humidity below 80%. The best result is achieved when the temperature of the air is between +23°C and +38°C, the relative humidity of the air is 50-70% and the ventilation good.
Application with undiluted paint is recommended, but the paint can be diluted with water, if required.
The formation of foam caused by the application process can be reduced with the addition of 0.5% TEKNOPAINT ADDITIVE 7901-30 defoamer (over addition may cause defoamer defects in the paint film).
Storage
The storage stability is shown on the label. Store in a tightly closed container. The best storage temperature is +10°C - +25°C. Must not freeze.
Application methods
Depending on the colour.
| Solids | abt. 42 % by volume |
|---|---|
| Total mass of solids | abt. 990 g/l |
| Volatile organic compound (VOC) | abt. 16 g/l |
| Gloss | Matt |
| Drying time – touch dry | 30 min. |
| Thinner | Water. |
| Clean up | Water. |
| Colours | Light shades. |
| Safety markings | See safety data sheet. |