SILORA LW

Light wet room filler

  • Water-borne
  • Filler

Ready-to-use, water-borne light filler for wet areas.

Used for filling of joints and overall skimming of walls and ceilings in wet interior areas before attaching the plastic cover, tiling or painting. The substrate can be gypsum board, fibre board, concrete, lightweight concrete, plaster etc. Also suitable for smoothing out of board joints and for attaching jointing tape. A CE approved joint tape must be used for taping gypsum board joints. SILORA LW has good adhesion and filling capability. The filler contains a long-acting agent against mildew.

Surface preparation

Clean new surfaces from dust and dirt. Wash previously painted surfaces with RENSA SUPER paint cleaner. Matt down hard or gloss surfaces by sanding and thereafter remove the dust. Brittle surfaces and untreated wooden surfaces must be primed before the filler is applied.

Application

Apply the filler by trowel. The number of layers is dependent on the surface roughness. The dried filler can be painted or wall-papered. Before wall-papering the filler surfaces must be primed with adhesive or painted with TAPETTIPOHJAMAALI. The use of protective mask for eyes and face is recommended when grinding the filler.

Application conditions

The surface to be treated must be dry. During the application and drying period the temperature of the ambient air, the surface and the product shall be above +5°C and the relative air humidity below 80%.

Storage

Store in a cool place. Must not freeze. Storage stability is 1 year in unopened package.
Volatile organic compound (VOC) The product is not included in the EU VOC directive.
Density abt. 1 g/ml
Practical spreading rate For skimming the entire surface, 1 l/m² with 1 mm layer thickness. For partial filling of surfaces and filling of joints, two layers on gypsum board, abt. 0.3 l/m².
Particle size 0.2
Clean up Water.
Colours Bluish grey.
Packages 0.4 l, 3 l, 10 l.
Safety markings See safety data sheet.
Approvals & certificates CE marking